Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SILVERADO CLASSIC 3500 2WD V8-6.0LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL TESTING - REMOTE FUNCTIONSSCAN TOOL DATA DEFINITIONS
2007 Chevrolet Silverado Classic 3500 2WD V8-6.0L
Scan Tool Data Definitions
2007 Chevrolet Silverado Classic 3500 2WD V8-6.0LSECTION Scan Tool Data Definitions
Scan Tool Data Definitions
Fob 1 Battery
- The scan tool displays OK to indicate a good battery voltage level was last received.
Fob 2 Battery
- The scan tool displays OK to indicate a good battery voltage level was last received.
Fob 3 Battery
- The scan tool displays OK to indicate a good battery voltage level was last received.
Fob 4 Battery
- The scan tool displays OK to indicate a good battery voltage level was last received.
Last Fob Button Pressed
- The scan tool displays Dr. Door Unlock, All Door Unlock, Door Lock, Rear Release or Panic Alarm indicating the last input received from a programmed fob.
Last Fob Used
- The scan tool displays FOB 1-4 to indicate the number of the last transmitter used
Fob 1 Programmed
- The scan tool displays Yes/No. The scan tool displays Yes if a transmitter is programmed to this numeric position.
Fob 2 Programmed
- The scan tool displays Yes/No. The scan tool displays Yes if a transmitter is programmed to this numeric position.
Fob 3 Programmed
- The scan tool displays Yes/No. The scan tool displays Yes if a transmitter is programmed to this numeric position.
Fob 4 Programmed
- The scan tool displays Yes/No. The scan tool displays Yes if a transmitter is programmed to this numeric position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.