Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SILVERADO CLASSIC 2500 4WD V8-6.0LREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGCONTROL MODULE SETUP
2007 Chevrolet Silverado Classic 2500 4WD V8-6.0L
Control Module Setup
2007 Chevrolet Silverado Classic 2500 4WD V8-6.0LSECTION Control Module Setup
Control Module Setup
Passenger Door Module (PDM) Setup
After passenger door module (PDM) switch assembly replacement, the following procedures must be performed in the order that they appear for the Tire Pressure Monitor (TPM) System to function properly. The PDM also requires keyless entry transmitter programming after replacement. Refer to Transmitter Synchronization.
TPM System Enable
The service replacement PDM switch assembly comes with the TPM System disabled to allow the same part number PDM to be used in both TPM and non-TPM equipped vehicles. Once the TPM option is enabled in the PDM, it cannot be disabled. Before proceeding with the steps below, ensure the vehicle is equipped with TPM (UJ6). Refer to Vehicle Certification, Tire Placard, Anti-Theft, and Service Parts ID Label.
1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With the scan tool, select Chassis.
4. Select Tire Pressure Monitor.
5. Select Special Functions.
6. Select TPM Option Enable.
7. Press the exit key to escape.
Tire Type/Pressure Selection
Since there are different tire types and pressure combinations for different vehicles, it is necessary to select the correct tire type and tire pressures for the vehicle being serviced.
1. Install a scan tool.
2. Turn ON the ignition, with the engine OFF.
3. With the scan tool, select Chassis.
4. Select Tire Pressure Monitor.
5. Select Special Functions.
6. Select Tire Type/Pressure Selection.
7. Select P-Metric Standard.
8. Select the front tire pressure as noted on the vehicle driver door placard sticker.
9. Select the rear tire pressure as noted on the vehicle driver door placard sticker.
10. Verify the selections made are correct and press the enter key. The scan tool will flash Procedure in Progress, then display Procedure Complete.
11. Press the exit key to escape.
Tire Pressure Sensor Learn
After PDM switch assembly replacement, each of the tire pressure sensors unique identification codes must be learned into the PDM memory. Refer to Tire Pressure Sensor Learn.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.