Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SILVERADO CLASSIC 2500 4WD V8-6.0LREPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2007 Chevrolet Silverado Classic 2500 4WD V8-6.0L
Scan Tool Data Definitions
2007 Chevrolet Silverado Classic 2500 4WD V8-6.0LSECTION Scan Tool Data Definitions
Scan Tool Data Definitions
The SIR scan tool data definitions contain a brief description of all SIR related parameters available on the scan tool. The parameters that are available on the scan tool are listed below in alphabetical order.
8-Digit GM Part Number
- The scan tool displays an 8-digit part number. This number is the GM part number that is stored within the SDM memory.
Active Switch
- The scan tool displays enabled or disabled. The signal from the inflatable restraint I/P module disable switch indicates whether the passenger frontal air bag is enabled or disabled.
Calibration ID
- The scan tool displays a 4-digit number. This calibration ID is the check sum of the SDM read only memory contents.
Component Serial Number
- The scan tool displays the digits of the SDM serial number.
Driver Side Belt Status
- The scan tool displays buckled or unbuckled. The signal from the driver seat belt switch indicates whether the driver seat belt is buckled or unbuckled.
Front End Sensor #1 ID
- The scan tool displays a 2-digit ID number. The ID signal sent to the SDM from the left front end sensor.
Front End Sensor #2 ID
- The scan tool displays a 2-digit ID number. The ID signal sent to the SDM from the right front end sensor.
Ignition Voltage
- The scan tool displays 0-20 volts. Ignition represents the system voltage measured by the SDM at its ignition 1 voltage feed.
Julian Date of Build
- The scan tool displays a 3-digit number. An example would be 723. 723 is July 23 which is day 204 based on the Julian Calendar.
Passenger Side Belt Status
- The scan tool displays buckled or unbuckled. The signal from the passenger seat belt switch indicates whether the passenger seat belt is buckled or unbuckled.
Passenger Side Impact Sensor (SIS) ID, (RPO HP2)
- The scan tool displays a 2-digit ID number. The ID signal sent to the SDM from the SIS.
ROM ID
- The scan tool displays a 4-digit number. This number is the read-only memory (ROM) ID.
Year Module Built
- The scan tool displays what year the module was built.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.