Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SILVERADO CLASSIC 1500 4WD V8-5.3LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - WINDOWS AND GLASSPOWER WINDOW CONTROL MODULESERVICE AND REPAIRFRONT SIDE DOOR WINDOW MODULE REPLACEMENT
2007 Chevrolet Silverado Classic 1500 4WD V8-5.3L
Front Side Door Window Module Replacement
2007 Chevrolet Silverado Classic 1500 4WD V8-5.3LSECTION Front Side Door Window Module Replacement
FRONT SIDE DOOR WINDOW MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Raise and support the window.
2. Remove the trim panel.
3. Remove the water deflector.
4. Disconnect the wiring harness from the window motor assembly.
5. Remove the 2 bolts holding the window to the regulator.
6. Remove the bolts from the window regulator.
7. Remove the window regulator assembly from the door folding both sides together.
INSTALLATION PROCEDURE
1. Install the regulator to the door.
2. NOTE: Refer to Fastener Notice.
Install the bolts to the window regulator.
Tighten the bolts to 9 N.m (80 lb in).
3. Align the window to the regulator and install the bolts holding the window to the regulator.
Tighten the bolts to 9 N.m (80 lb in).
4. Connect the wiring harness to the window motor assembly.
5. Install the water deflector.
6. Install the trim panel.
7. Lower the window. Inspect the window operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.