Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SILVERADO CLASSIC 1500 4WD V8-4.8LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL ASSEMBLYSERVICE AND REPAIRHVAC SYSTEM - MANUAL
2007 Chevrolet Silverado Classic 1500 4WD V8-4.8L
HVAC System - Manual
2007 Chevrolet Silverado Classic 1500 4WD V8-4.8LSECTION HVAC System - Manual
HVAC Control Module Replacement
Removal Procedure
1. Remove the instrument cluster trim plate bezel.
2. Remove the instrument panel storage tray.
3. Remove the accessory switch assembly from the instrument panel.
4. Remove the screws from the HVAC control assembly.
5. Remove the HVAC control assembly, with the following procedure:
1. Release the retaining tabs.
2. Pull the control head out of the instrument panel carrier.
6. Disconnect the electrical connectors from the HVAC control assembly.
Installation Procedure
Important: The Key should be in the off position when connecting the electrical connectors to ensure proper calibration.
1. Connect the electrical connectors to the HVAC control assembly.
2. Install the HVAC control assembly.
3. Install the accessory switch assembly to the instrument panel.
Notice: Refer to Fastener Notice.
4. Install the screws from the HVAC control assembly.
Tighten the screws to 1.9 N.m (17 lb in).
5. Install the instrument panel storage tray.
6. Install the instrument cluster trim plate bezel.
Important: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating.
If interrupted improper HVAC performance will result.
7. Start the vehicle and let run for one minute.
8. Refer to Control Module References for programming and setup information. Programming and Relearning
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.