Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SILVERADO CLASSIC 1500 2WD V8-6.0LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRFRONT SIDE DOOR WINDOW CHANNEL REPLACEMENT
2007 Chevrolet Silverado Classic 1500 2WD V8-6.0L
Front Side Door Window Channel Replacement
2007 Chevrolet Silverado Classic 1500 2WD V8-6.0LSECTION Front Side Door Window Channel Replacement
FRONT SIDE DOOR WINDOW CHANNEL REPLACEMENT
REMOVAL PROCEDURE
1. Remove the window.
2. Remove the window glass weatherstrip.
3. Remove the window run channel bolts.
4. Remove the front and the rear window run channels from the door.
INSTALLATION PROCEDURE
1. Install the front and the rear window run channels to the door.
2. Install the front and the rear window run channel bolts.
1. Tighten the front bolt to 9 N.m (80 lb in).
2. NOTE: Refer to Fastener Notice.
Tighten the rear bolt to 9 N.m (80 lb in).
3. Install the window glass weatherstrip.
4. Install the window.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.