Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007SILVERADO CLASSIC 1500 2WD V8-6.0LREPAIR AND DIAGNOSISBODY AND FRAMESEATSMEMORY POSITIONING SYSTEMSMEMORY POSITIONING SWITCHSERVICE AND REPAIR
2007 Chevrolet Silverado Classic 1500 2WD V8-6.0L
Memory Positioning Switch: Service and Repair
2007 Chevrolet Silverado Classic 1500 2WD V8-6.0LSECTION Service and Repair
DRIVER SEAT ADJUSTER MEMORY SWITCH REPLACEMENT
REMOVAL PROCEDURE
1. Remove the front door trim panel.
2. Disconnect the electrical connector.
3. Release the front seat memory switch assembly retaining clips in order to remove the switch.
4. Remove the front seat memory switch assembly.
INSTALLATION PROCEDURE
1. Install the front seat memory switch assembly to the front trim panel by pressing into place until fully seated.
2. Connect the electrical connector to the front seat memory switch assembly.
3. Install the front trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.