Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007IMPALA V8-5.3LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTDIAGRAMSELECTRICAL DIAGRAMS
2007 Chevrolet Impala V8-5.3L
Electrical Diagrams
2007 Chevrolet Impala V8-5.3LSECTION Electrical Diagrams
ENGINE CONTROLS SCHEMATICS
ECM Power, Ground, MIL, and Serial Data
5-Volt and Low Reference Bussing
MAP, ECT, and MAF/IAT Sensors
Heated Oxygen Sensors
Electronic Throttle Controls
Ignition Controls Bank 1 (Odd) Ignition Coils
Ignition Controls Bank 2 (Even) Ignition Coils
Ignition Controls Knock, CMP, CKP, Brake Booster Vacuum Sensors, and Valve Lifter Oil Manifold Assembly
Fuel Pump Controls
Fuel Injectors
EVAP Solenoids and FTP Sensor
Controlled/Monitored Subsystem References
Locations: The locations for the Connectors, Grounds, Splices, and Grommets shown within these diagrams can be found via their numbers at Vehicle Locations. Locations
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.