Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007IMPALA V6-3.9LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRREAR SIDE DOOR WINDOW CHANNEL REPLACEMENT
2007 Chevrolet Impala V6-3.9L
Rear Side Door Window Channel Replacement
2007 Chevrolet Impala V6-3.9LSECTION Rear Side Door Window Channel Replacement
Rear Side Door Window Channel Replacement
Removal Procedure
Notice: Refer to Paint Damage Notice.
1. Apply masking tape to the door frame and applique.
2. Remove the rear door trim panel.
3. Remove the rear door water deflector.
4. Position the window in the full down position.
5. Remove the window channel bolt (2).
6. Remove the window channel from the door.
Installation Procedure
1. Install the window channel (1) in the door.
Notice: Refer to Fastener Notice.
2. Install the window run channel bolts (2).
Tighten the bolts to 10 N.m (89 lb in).
3. Inspect the window for proper operation.
4. Remove the masking tape from the frame and applique.
5. Install the rear door water deflector.
6. Install the rear door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.