Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Automatic Transmission Control Replacement
2007 Chevrolet Impala V6-3.9LSECTION Automatic Transmission Control Replacement
Automatic Transmission Control Replacement
Removal Procedure
1. Remove the console trim plate.
2. Remove the console wiring harness.
3. Remove the console shift control wiring harness.
4. Remove the automatic transaxle range selector cable.
5. Disconnect the lightbulb and the retainer from the shiftier.
6. Remove the console shift control retaining nuts.
7. Remove the console shift control assembly from the vehicle.
Installation Procedure
1. Install the console shift control into the vehicle.
Notice: Refer to Fastener Notice.
2. Install the console shift control retaining nuts.
Tighten the console shift control retaining nuts to 24 N.m (18 lb ft).
3. Install the automatic transaxle range selector cable.
4. Install the console shift control wiring harness.
5. Install the console wiring harness.
6. Install the console trim plate.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.