Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007IMPALA V6-3.9LREPAIR AND DIAGNOSISLIGHTING AND HORNSVANITY LAMPSERVICE AND REPAIR
2007 Chevrolet Impala V6-3.9L
Vanity Lamp: Service and Repair
2007 Chevrolet Impala V6-3.9LSECTION Service and Repair
Vanity Mirror Lamp Bulb Replacement
Removal Procedure
1. Lower the sunshade and open the illuminated mirror door.
2. Insert a small flat-bladed tool at the outer edge of the lamp lens in the slot. Carefully press down to remove the lens.
3. Remove the bulb.
Installation Procedure
1. Install the bulb.
2. Align the upper lens tab to the opening. Insert the upper edge of the lens.
3. Insert a small flat-bladed tool at the outer edge of the lamp lens. Carefully press up to install the lens.
4. Close the illuminated mirror door and raise the sunshade.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.