Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007IMPALA V6-3.5LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRREAR WINDOW REVEAL MOLDING REPLACEMENT
2007 Chevrolet Impala V6-3.5L
Rear Window Reveal Molding Replacement
2007 Chevrolet Impala V6-3.5LSECTION Rear Window Reveal Molding Replacement
Rear Window Reveal Molding Replacement
The rear window reveal molding is an applied molding design separate from the window. The rear window reveal molding is bonded to the rear window and may be bonded to the body. The rear window reveal molding may be replaced with rear window as an assembly, or the rear window reveal molding may be available as a separate service part. Refer to Urethane Adhesive Installation of Stationary Windows.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.