Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007IMPALA V6-3.5LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIRFRONT SIDE DOOR WINDOW WEATHERSTRIP REPLACEMENT
2007 Chevrolet Impala V6-3.5L
Front Side Door Window Weatherstrip Replacement
2007 Chevrolet Impala V6-3.5LSECTION Front Side Door Window Weatherstrip Replacement
Front Side Door Window Weatherstrip Replacement
Removal Procedure
1. Remove the front door trim panel.
2. Remove the front door water deflector.
3. Remove the front door outer belt sealing strip.
4. Remove the front door window.
5. Remove the screws from the front door window channel.
6. Remove the front door window channel from the front door frame.
7. Remove the front door window channel from the front door.
8. Remove the screw from the front door rear window channel.
9. Remove the front door rear window channel from the front door slot by pulling down to disengage the retainer clip.
10. Remove the front door rear window channel from the front door through the access hole in the inner front door panel.
Installation Procedure
1. Position the front door window channel front channel into the front door.
Notice: Refer to Fastener Notice.
2. Install the front door window channel screws.
Tighten the front door window channel screws to 10 N.m (89 lb in).
3. Install the front door window channel to the front door starting in the top corner working out in both directions.
Firmly seat the front door window channel to the front door.
4. Install the front door rear window channel to the front door through the access hole in the inner front door panel.
5. Install the front door rear window channel to the front door slot by pushing up to engage the retainer clip.
6. Install the screw to the front door rear window channel.
Tighten the front door weatherstrip channel screws to 10 N.m (89 lb in).
7. Install the front door window.
8. Inspect the front door window for proper operation.
9. Install the front door outer belt sealing strip.
10. Install the front door water deflector.
11. Install the front door trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.