Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Oil Pressure Sensor: Service and Repair
2007 Chevrolet Impala V6-3.5LSECTION Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the oil pressure sensor heat shield nut and shield.
3. Disconnect the engine oil pressure sensor electrical connector (1).
4. Remove the engine oil pressure sensor.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the engine oil pressure sensor.
Tighten the sensor to 16 N.m (12 lb ft).
2. Connect the engine oil pressure sensor electrical connector (1).
3. Install the oil pressure sensor heat shield and nut.
Tighten the nut to 10 N.m (89 lb in).
4. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.