Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007IMPALA V6-3.5LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL SWITCHSERVICE AND REPAIRTURN SIGNAL SWITCH HOUSING REPLACEMENT
2007 Chevrolet Impala V6-3.5L
Turn Signal Switch Housing Replacement
2007 Chevrolet Impala V6-3.5LSECTION Turn Signal Switch Housing Replacement
Turn Signal Switch Housing Replacement
Removal Procedure
Caution: Refer to SIR Caution.
1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the tilt head components.
3. Remove the turn signal and multifunction switch assembly only.
4. Slide the turn signal switch housing off of the steering column shaft assembly.
Installation Procedure
Important: The switch mounting bracket must be pressed firmly against the steering column tilt head.
1. Slide the turn signal switch housing onto the steering column shaft assembly.
2. Install the turn signal and multifunction switch assembly only.
3. Install the tilt head components.
4. Enable the SIR system. Refer to SIR Disabling and Enabling.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.