Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007HHR L4-2.4LREPAIR AND DIAGNOSISSERVICE AND REPAIRREMOVAL AND REPLACEMENTRELAY REPLACEMENT - WITHIN AN ELECTRICAL CENTER
2007 Chevrolet HHR L4-2.4L
Relay Replacement - Within an Electrical Center
2007 Chevrolet HHR L4-2.4LSECTION Relay Replacement - Within an Electrical Center
RELAY REPLACEMENT (WITHIN AN ELECTRICAL CENTER)
TOOLS REQUIRED
J 43244 Relay Puller Pliers
REMOVAL PROCEDURE
1. Remove the electrical center cover.
2. Locate the relay.
3. IMPORTANT:
- Always note the orientation of the relay.
- Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
Using the J 43244 (1) position the tool on opposing corners of the relay (2).
4. NOTE: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
Remove the relay (2) from the electrical center.
INSTALLATION PROCEDURE
1. Install the relay (2) in the same position as removed.
2. Install the electrical center cover
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.