Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Injector Coil Test (W/J39021 or W/Tech 2)
2007 Chevrolet HHR L4-2.4LSECTION Fuel Injector Coil Test (W/J39021 or W/Tech 2)
Fuel Injector Coil Test
Verify the resistance of each fuel injector with one of the following methods:
* If the engine coolant temperature (ECT) sensor is between 10-32°C (50-90°F), the resistance of each fuel injector should be 11-14 ohms.
• If the injectors measure OK, perform the Fuel Injector Balance Test - Fuel Pressure Test. Fuel Injector Balance Test-Fuel Pressure Test
• If not within the specified range, replace the fuel injector.
* If the ECT sensor is not between 10-32°C (50-90°F), measure and record the resistance of each fuel injector with a DMM. Subtract the lowest resistance value from the highest resistance value. The difference between the lowest value and the highest value should be equal to or less than 3 ohms.
• If the difference is equal to or less than 3 ohms, refer to Fuel Injector Balance Test - Fuel Pressure Test for further diagnosis of the fuel injectors. Fuel Injector Balance Test-Fuel Pressure Test
• If the difference is more than 3 ohms, add all of the fuel injector resistance values to obtain a total resistance value. Divide the total resistance value by the number of fuel injectors to obtain an average resistance value. Subtract the lowest individual fuel injector resistance value from the average resistance value. Compute the difference between the highest individual fuel injector resistance value and the average resistance value. Replace the fuel injector that displays the greatest difference above or below the average.
Important:
* DO NOT perform this test if the engine coolant temperature (ECT) is above 94°C (201°F). Irregular fuel pressure readings may result due to hot soak fuel boiling.
* Verify that adequate fuel is in the fuel tank before proceeding with this diagnostic.
* Before proceeding with this test review the User Manual CH 48027-5 for Safety Information and Instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.