Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Accelerator Pedal Position Sensor: Service and Repair
2007 Chevrolet HHR L4-2.4LSECTION Service and Repair
Accelerator Pedal Position Sensor Replacement
Removal Procedure
1. Remove the knee bolster.
2. Remove the insulator panel.
3. Disconnect the accelerator pedal position (APP) sensor electrical connector (1).
4. Remove the APP sensor nuts.
5. Remove the APP sensor.
Installation Procedure
1. Install the APP sensor.
Notice: Refer to Fastener Notice.
2. Install the APP sensor nuts.
Tighten the nuts to 10 N.m (89 lb in).
3. Connect the APP sensor electrical connector (1).
4. Install the insulator panel.
5. Install the knee bolster.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.