Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Channel Plate Assembly Installation
2007 Chevrolet HHR L4-2.2LSECTION Channel Plate Assembly Installation
Channel Plate Assembly Installation
Tools Required
J 36850 TRANSJEL(TM)
1. Install the channel plate to drive sprocket thrust washer (34) onto the channel plate (27).
2. Retain the thrust washer (34) with J 36850 or equivalent.
3. Install a new channel plate to case gasket (28) onto the transmission case (51).
4. Install the channel plate assembly onto the transmission case (51). The channel plate should fit tightly over the guide pins (45) located on the transmission case (51).
Notice: Refer to Fastener Notice.
5. Install the two channel plate to driven sprocket support bolts (25).
Tighten the two channel plate to driven sprocket bolts (25) to 14 N.m (10.5 lb ft).
6. Install the six channel plate to case bolts (25). Hand tighten the bolts.
Tighten the six channel plate to case bolts and the two channel plate to driven sprocket support bolts to 12 N.m (9 lb ft).
7. Install the two channel plate to case bolts (8). Hand tighten bolts.
Tighten the two channel plate to case bolts (8) to 14 N.m (10.5 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.