Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007HHR L4-2.2LREPAIR AND DIAGNOSISRESTRAINTS AND SAFETY SYSTEMSAIR BAG SYSTEMSLOCATIONSSIR IDENTIFICATION VIEWS
2007 Chevrolet HHR L4-2.2L
SIR Identification Views
2007 Chevrolet HHR L4-2.2LSECTION SIR Identification Views
SIR Identification Views
The SIR Identification Views shown below illustrate the approximate location of all SIR components available for the vehicle. This will assist in determining the appropriate SIR Disabling and Enabling for a given service procedure, refer to SIR Disabling and Enabling.
1 - Front End Sensor-Located under the hood at the front of the vehicle
2 - Front Hood Assist Rod-A gas shock located under the front hood on the passenger side
3 - I/P Air Bag-Located at the top right under the instrument panel
4 - Roof Rail Air Bag-Located under the headliner, extending from the passenger front windshield pillar to the passenger rear windshield pillar
5 - Side Impact Sensor (SIS)-Located behind door panel on the passenger front door
6 - Sensing and Diagnostic Module (SDM)-Located underneath the vehicle carpet under the center console
7 - Passenger Presence System-Located on the front passenger seat under the seat bottom trim
8 - Seat Belt Retractor Pretensioner-Located under the trim near the bottom of the center pillar on the passenger side of vehicle
9 - Inflator Module for Roof Rail Air Bag-Located behind the garnish molding on the upper rear pillar
10 - Rear Hood Assist Rod-A gas shock located under the rear truck lid on the passenger side
11 - Vehicle Battery-Located in the trunk under the carpet
12 - Rear Hood Assist Rod-A gas shock located under the rear truck lid on the driver side
13 - Inflator Module for Roof Rail Air Bag-Located behind garnish molding on the upper rear pillar
14 - Seat Belt Retractor Pretensioner-Located under the trim near the bottom of the center pillar on the driver side of vehicle
15 - Body Control Module/Fuse Block-Air Bag and SDM Fuse-Located on RH side of the center console
16 - Side Impact Sensor (SIS)-Located behind door panel on the driver front door
17 - Roof Rail Air Bag-Located under the headliner, extending from the driver front windshield pillar to the driver rear windshield pillar
18 - Steering Wheel Air Bag-Located on the steering wheel
19 - Front Hood Assist Rod-A gas shock located under the front hood on the driver side
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.