Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Getrag 5 Speed - Manual Transmission
2007 Chevrolet HHR L4-2.2LSECTION Getrag 5 Speed - Manual Transmission
Vehicle Speed Sensor Replacement
Removal Procedure
1. Disconnect the vehicle speed sensor (VSS) electrical connector.
2. Remove the retainer bolt.
3. Remove the retainer.
4. Pull up on the VSS in order to remove the VSS from the transaxle.
5. Remove the O-ring.
Installation Procedure
1. Lubricate a new O-ring with DEXRON III transmission fluid.
2. Install the new O-ring.
3. Install the VSS assembly.
4. Install the VSS retainer.
Notice: Refer to Fastener Notice.
5. Install the VSS retainer bolt.
Tighten the bolt to 12 N.m (8 lb ft).
6. Connect the VSS connector to the VSS.
7. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.