Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007HHR L4-2.2LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL SWITCHSERVICE AND REPAIR
2007 Chevrolet HHR L4-2.2L
Turn Signal Switch: Service and Repair
2007 Chevrolet HHR L4-2.2LSECTION Service and Repair
Turn Signal Multifunction Switch Replacement
Removal Procedure
1. Remove the steering column trim covers.
2. Disconnect the turn signal multifunction switch electrical connector.
3. Depress the locking tabs and remove the turn signal multifunction switch (1).
Installation Procedure
1. Install the turn signal multifunction switch (1). Ensure the locking tabs are snapped into place.
2. Connect the turn signal multifunction switch harness connector.
3. Install the steering column trim covers.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.