Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007EXPRESS 2500 V8-6.0LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINDIFFERENTIAL ASSEMBLYSPECIFICATIONSCAPACITY SPECIFICATIONS
2007 Chevrolet Express 2500 V8-6.0L
Capacity Specifications
2007 Chevrolet Express 2500 V8-6.0LSECTION Capacity Specifications
DIFFERENTIAL FLUID
8.6 INCH REAR AXLE
The distance from the bottom edge of the fill plug hole and the lubricant level should be 15-40 mm (0.6-1.6 in).
If the measurement is greater than 40 mm (1.6 in), add lubricant until the level is between 15-40 mm (0.6-1.6 in) from the bottom edge of the fill plug hole.
9.75, 10.5 INCH REAR AXLE
The lubricant level should be between 0-6 mm (0-0.25 in) below the fill plug opening.
If the level is low, add lubricant until the level is even with the bottom edge of the fill plug opening.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.