Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007EXPRESS 2500 V8-6.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSTESTING AND INSPECTION4L80-E/4L85-E AUTOMATIC TRANSMISSIONSCAN TOOL DATA LIST
2007 Chevrolet Express 2500 V8-6.0L
Scan Tool Data List
2007 Chevrolet Express 2500 V8-6.0LSECTION Scan Tool Data List
Scan Tool Data List (4.8L and 6.0L)
Use the Scan Tool Data List under the following conditions:
* The Diagnostic System Check - Vehicle is complete.
* The on-board diagnostics are functioning properly.
* No diagnostic trouble codes (DTCs) are present.
The values below represent a typical display recorded from a properly functioning system.
Important: Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.
Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.
Scan tool values below were recorded under the following conditions:
* Engine at idle
* Upper radiator hose hot
* Closed throttle
* Transmission in Park
* Closed Loop Operation
* Accessories OFF
* Brake pedal not applied
Scan Tool Data List:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.