Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007EXPRESS 2500 V8-6.0LREPAIR AND DIAGNOSISLIGHTING AND HORNSFOG/DRIVING LAMPSERVICE AND REPAIR
2007 Chevrolet Express 2500 V8-6.0L
Fog/Driving Lamp: Service and Repair
2007 Chevrolet Express 2500 V8-6.0LSECTION Service and Repair
REAR FOG LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Disconnect the electrical connector from the lamp assembly.
2. Remove the nut retaining the lamp assembly to the bracket.
3. Remove the lamp assembly from the bumper.
INSTALLATION PROCEDURE
1. Install the lamp assembly to the bumper.
2. NOTE: Refer to Fastener Notice.
Install the nut to retain the lamp assembly to the bracket.
Tighten the nut to 2 N.m (18 in lb).
3. Install the electrical connector to the lamp assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.