Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007COBALT L4-2.2LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER BLADESERVICE AND REPAIRWIPER ARM BLADE REPLACEMENT
2007 Chevrolet Cobalt L4-2.2L
Wiper Arm Blade Replacement
2007 Chevrolet Cobalt L4-2.2LSECTION Wiper Arm Blade Replacement
WIPER ARM BLADE REPLACEMENT
REMOVAL PROCEDURE
1. Move the wiper arm to the service up position
2. Press the wiper blade clip button in to release the wiper blade from the inside radius of the wiper arm.
3. Remove the wiper blade out through the opening in the wiper arm.
INSTALLATION PROCEDURE
1. Install the hook of the wiper arm through the opening in the wiper blade.
2. Press the wiper blade pivot into the wiper arm hook until the pivot locks into the hook.
3. Position the wiper blade pivot in the inside radius of the wiper arm hook.
4. Move the wiper arm back to the parked position.
5. Operate the windshield wipers and inspect for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.