Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
43. Input Speed Sensor Installation
2007 Chevrolet Cobalt L4-2.2LSECTION 43. Input Speed Sensor Installation
Input Speed Sensor Installation
Important: The tab on the sensor housing (46) fits into the recess on the case boss.
Important: For drive sprockets with 35 teeth, use a black sensor housing. For drive sprockets with 32 or 33 teeth, use a natural colored sensor housing.
1. Assemble the input speed sensor (46) to the transmission case.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the input speed sensor bolt (15). Hand start the bolts.
Tighten the input speed sensor bolt to 12 N.m (9 lb ft).
3. Route the input speed sensor wiring harness in the case channel.
4. Connect the input speed sensor connector to the input speed sensor.
5. Install the wire harness retainer and wire harness retainer bolt.
Tighten the wire harness retainer bolt to 12 N.m (9 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.