Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007COBALT L4-2.2LREPAIR AND DIAGNOSISMAINTENANCEFLUIDSFLUID - M/TTESTING AND INSPECTION
2007 Chevrolet Cobalt L4-2.2L
Fluid - M/T: Testing and Inspection
2007 Chevrolet Cobalt L4-2.2LSECTION Testing and Inspection
Transmission Fluid Checking
1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation (5 Lug Wheel).
Important: Inspect the fluid level only when the engine is off. Ensure the vehicle is level. The transaxle must be cold.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the level check plug.
4. Verify that the fluid is up to the opening.
5. If no fluid is visible, add Dexron III P/N 21019223 Transmission Fluid, or equivalent until the level check opening begins to leak fluid.
Notice: Refer to Fastener Notice.
6. Install the fluid level check plug.
Tighten the fluid level check plug to 38 N.m (28 lb ft).
7. Install the left front wheel. Refer to Tire and Wheel Removal and Installation (4 Lug Wheel) Tire and Wheel Removal and Installation (5 Lug Wheel).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.