Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007COBALT L4-2.2LREPAIR AND DIAGNOSISLIGHTING AND HORNSHORNSERVICE AND REPAIR
2007 Chevrolet Cobalt L4-2.2L
Horn: Service and Repair
2007 Chevrolet Cobalt L4-2.2LSECTION Service and Repair
HORN REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left headlamp housing bracket.
2. Disconnect the horn electrical connector.
3. Remove the horn bracket bolt (1).
4. Remove the horn (2) from the front frame rail.
INSTALLATION PROCEDURE
1. Position the horn (2) into the slot in the front frame rail.
2. NOTE: Refer to Fastener Notice.
Install the horn bracket bolt (1).
Tighten the bolt to 10 N.m (89 lb in).
3. Connect the horn electrical connector.
4. Install the left headlamp housing bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.