Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007COBALT L4-2.2LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINEINTAKE MANIFOLDSERVICE AND REPAIRINTAKE MANIFOLD COVER REPLACEMENT
2007 Chevrolet Cobalt L4-2.2L
Intake Manifold Cover Replacement
2007 Chevrolet Cobalt L4-2.2LSECTION Intake Manifold Cover Replacement
Intake Manifold Cover Replacement
Removal Procedure
1. Remove the engine oil fill cap.
2. Grasp the intake manifold cover by the lower right inboard corner and pull up to disengage the cover from the stud.
3. Grasp the intake manifold cover by the upper left corner and pull up to disengage the cover from the stud.
4. Remove the intake manifold cover.
Installation Procedure
1. Place the intake manifold cover onto the engine over the studs.
2. Push down on the intake manifold cover directly over the lower right stud in order to engage the cover to the stud.
3. Push down on the intake manifold cover directly over the upper left stud in order to engage the cover to the stud.
4. Install the engine oil fill cap.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.