Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007AVEO L4-1.6LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER MOTORSERVICE AND REPAIRWIPER MOTOR REPLACEMENT
2007 Chevrolet Aveo L4-1.6L
Wiper Motor Replacement
2007 Chevrolet Aveo L4-1.6LSECTION Wiper Motor Replacement
Wiper Motor Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
2. Put the wiper arms in the upright position.
3. Remove the left side portion of the air inlet grille panel.
4. Remove the nut securing the wiper arm linkage to the motor drive shaft.
5. Pry the wiper arm linkage off the motor drive shaft.
6. Disconnect the electrical connectors.
7. Remove the bolts and the wiper motor.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the wiper motor with the bolts.
Tighten the wiper motor bolts to 9 N.m (80 lb in).
2. Connect the electrical connector.
3. Press the wiper arm linkage onto the motor drive shaft.
4. Install the wiper arm linkage to the motor drive shaft with the nut.
Tighten the wiper arm linkage nut to 8.5 N.m (75 lb in).
5. Install the left side portion of the air inlet grille panel.
6. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.