Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007AVEO L4-1.6LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRTURN SIGNAL MULTIFUNCTION SWITCH REPLACEMENT
2007 Chevrolet Aveo L4-1.6L
Turn Signal Multifunction Switch Replacement
2007 Chevrolet Aveo L4-1.6LSECTION Turn Signal Multifunction Switch Replacement
Turn Signal Multifunction Switch Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the lower steering column cover panel screws (6, 7, 8) and remove the lower steering column cover panel (5).
3. Turn the steering wheel to expose the upper steering column cover panel screws (3, 4). Remove the upper steering column cover panel screws and remove the upper steering column cover panel.
4. Remove the turn signal switch by pushing in on the tabs (2, 3) on either side of the switch housing.
5. Disconnect the electrical connectors (1, 4) from the turn signal switch.
Installation Procedure
1. Connect the electrical connectors (1, 4) to the turn signal switch.
2. Install the turn signal switch into the switch housing.
Notice: Refer to Fastener Notice.
3. Turn the steering wheel. Install the upper steering column cover panel (1) and the screws (3, 4).
Tighten the upper steering column cover panel screws to 3 N.m (27 lb in).
4. Install the lower steering column cover panel (5) and the screws (6, 7, 8).
Tighten the lower steering column cover panel screws to 3 N.m (27 lb in).
5. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.