Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007AVEO L4-1.6LREPAIR AND DIAGNOSISSTARTING AND CHARGINGSTARTING SYSTEMSTARTER MOTORSERVICE AND REPAIR
2007 Chevrolet Aveo L4-1.6L
Starter Motor: Service and Repair
2007 Chevrolet Aveo L4-1.6LSECTION Service and Repair
Starter Motor Replacement (1.4L/1.5L SOHC and 1.4L/1.6L DOHC)
Removal Procedure
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
2. Remove the upper and the lower starter mounting bolts.
3. Remove the starter solenoid nuts to disconnect the electrical cable.
4. Remove the starter assembly.
Installation Procedure
1. Place the starter assembly in position.
Notice: Refer to Fastener Notice.
2. Install the upper and the lower starter mounting bolts.
Tighten the starter mounting bolts to 43 N.m (32 lb ft).
3. Position the starter electrical wire on the solenoid terminal.
4. Install the starter solenoid nuts.
Tighten the starter solenoid nuts to 15 N.m (11 lb ft).
5. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.