Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007AVEO L4-1.6LREPAIR AND DIAGNOSISMAINTENANCEDRIVE BELTSERVICE AND REPAIR
2007 Chevrolet Aveo L4-1.6L
Drive Belt: Service and Repair
2007 Chevrolet Aveo L4-1.6LSECTION Service and Repair
Power Steering Pump Drive Belt Replacement
Tools Required
J 23600-B Belt Tension Gage
Checking Belt Tension
Notice: Refer to Belt Dressing Notice.
1. Using the J 23600-B, check the tension on the pump drive belt.
2. If the J 23600-B does not indicate the proper tension, adjust the belt.
Adjusting Belt Tension
1. With the J 23600-B on the pump drive belt, loosen the alternator adjusting bolt and move the alternator until the gage indicates the proper tension.
Notice: Refer to Fastener Notice.
2. Tighten the alternator adjusting bolt.
Tighten the alternator adjusting bolt to 20 N.m (15 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.