Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007AVEO L4-1.6LREPAIR AND DIAGNOSISLIGHTING AND HORNSRELAYS AND MODULES - LIGHTING AND HORNSLAMP CONTROL MODULESERVICE AND REPAIR
2007 Chevrolet Aveo L4-1.6L
Lamp Control Module: Service and Repair
2007 Chevrolet Aveo L4-1.6LSECTION Service and Repair
Lamp Control Module Replacement
Replacement Procedure
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
2. Remove the instrument panel low cover.
3. Remove the screws and the lamp control module.
4. Disconnect the electrical connector.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the lamp control module with the screws.
2. Connect the electrical connector.
3. Install the instrument panel low cover.
4. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.