Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007AVEO L4-1.6LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCOMPRESSOR HVACCOMPRESSOR CLUTCH HUBSERVICE AND REPAIRCOMPRESSOR CLUTCH PLATE AND HUB ASSEMBLY REMOVAL
2007 Chevrolet Aveo L4-1.6L
Compressor Clutch Plate and Hub Assembly Removal
2007 Chevrolet Aveo L4-1.6LSECTION Compressor Clutch Plate and Hub Assembly Removal
Compressor Clutch Plate and Hub Assembly Removal
Tools Required
* J 33013-B Hub and Drive Plate Remover/Installer
* J 33027-A Clutch Hub Holding Tool
* J 42428 Compressor Holding Fixture
Disassembly Procedure
1. Remove the compressor.
2. Install the J 42428 to the compressor and hold the compressor holding fixture using a bench vise.
3. Use the J 33027-A to keep the clutch drive plate and the hub assembly from turning. Remove the shaft nut.
4. Thread the J 33013-B (1) into the hub. Hold the body of the remover with a wrench and turn the center screw into the remover body to remove the clutch drive plate and hub assembly.
5. Remove the clutch hub key. Retain the key for assembly (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.