Blower Motor Switch: Service and Repair

2007 Chevrolet Aveo L4-1.6LSECTION Service and Repair


Blower Motor Switch Replacement






Caution: Refer to Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Remove the HVAC control assembly.
3. Remove the screws that secure the switch assembly to the knob mount support.
4. Remove the switch assembly. Note the position of the spring, the electrical contact washer, and the contact key/keyway on the knob post.

Installation Procedure




1. Install the spring and the electrical contact washer over the blower switch knob post.
2. Align the contact key with the post keyway.
3. Position the switch assembly over the mount posts.
4. Install the switch assembly with the screws.
5. Connect the electrical connectors to the rear of the control assembly.
6. Install the HVAC control assembly.
7. Connect the negative battery cable.
8. Perform an operational check of the blower switch positions.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.