Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007AVEO L4-1.6LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGAMBIENT TEMPERATURE SENSOR / SWITCH HVACSERVICE AND REPAIR
2007 Chevrolet Aveo L4-1.6L
Ambient Temperature Sensor / Switch HVAC: Service and Repair
2007 Chevrolet Aveo L4-1.6LSECTION Service and Repair
Ambient Air Temperature Sensor Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
2. Remove the front bumper.
3. Disconnect the ambient air temperature sensor electrical connector.
4. Remove the ambient air temperature sensor from the bracket.
Installation Procedure
1. Install the ambient air temperature sensor into its bracket.
2. Connect the electrical connector.
3. Install the front bumper.
4. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.