Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2007AVEO L4-1.6LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMSERVICE AND REPAIR
2007 Chevrolet Aveo L4-1.6L
Disc Brake System: Service and Repair
2007 Chevrolet Aveo L4-1.6LSECTION Service and Repair
Front Brake Shield Replacement
Removal Procedure
1. Remove the rotor.
2. Remove the screws for the splash shield from the steering knuckle.
3. Remove the splash shield.
Installation Procedure
1. Install the splash shield.
Notice: Refer to Fastener Notice.
2. Secure the splash shield to the steering knuckle with the screws.
Tighten the splash shield-to-steering knuckle screws to 4 N.m (35 lb in).
3. Install the rotor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.