Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Front Wheel Speed Sensor Replacement
2007 Chevrolet Aveo L4-1.6LSECTION Front Wheel Speed Sensor Replacement
Front Wheel Speed Sensor Replacement
Removal Procedure
Caution: Refer to Battery Disconnect Caution.
1. Disconnect the negative battery cable.
Notice: Refer to Vehicle Lifting.
2. Raise and suitably support the vehicle.
3. Disconnect the electrical connector from the front wheel speed sensor.
4. Remove the bolt and the front wheel speed sensor from the steering knuckle.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the bolt and front wheel speed sensor to the steering knuckle.
Tighten the bolt to 9 N.m (80 lb in).
2. Connect the electrical connector to the front wheel speed sensor.
3. Lower the vehicle.
4. Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.