Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006TRAILBLAZER 4WD V8-6.0L VIN HREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGREFRIGERANT PRESSURE SENSOR / SWITCHSERVICE AND REPAIR
2006 Chevrolet TrailBlazer 4WD V8-6.0L VIN H
Refrigerant Pressure Sensor / Switch: Service and Repair
2006 Chevrolet TrailBlazer 4WD V8-6.0L VIN HSECTION Service and Repair
AIR CONDITIONING (A/C) REFRIGERANT PRESSURE SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector from the A/C refrigerant pressure sensor. The connector is accessible through the lower control arm.
3. Remove the A/C refrigerant pressure sensor from the compressor hose block.
4. Remove and discard the O-ring seal from the A/C refrigerant pressure sensor.
INSTALLATION PROCEDURE
1. Install the new O-ring seal.
2. Install the A/C refrigerant pressure sensor to the compressor hose block.
Tighten the A/C refrigerant pressure sensor to 4.8 N.m (42 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connector to the A/C refrigerant pressure sensor.
4. Leak test the fittings of the component using J 39400-A.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.