HVAC Control Module

2006 Chevrolet TrailBlazer 2WD V8-6.0L VIN HSECTION HVAC Control Module


HVAC CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE





1. Remove the I/P accessory trim plate.
2. Remove the HVAC control module screws.
3. Depress the HVAC control module tabs (3) and remove the HVAC control module (2) from the I/P (4).
4. Disconnect the electrical connectors (1) from the HVAC control module (2).

INSTALLATION PROCEDURE





1. Connect the electrical connectors (1) to the HVAC control module (2).
2. Install the HVAC control module (2) into the I/P (4).

IMPORTANT: Ensure that the HVAC control module tabs (3) lock into place.

3. Install the HVAC control module screws.

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice.

4. Install the I/P accessory trim plate.
5. Refer to Control Module References for programming and setup information. Programming and Relearning
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.