Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006TAHOE 4WD V8-5.3L VIN TREPAIR AND DIAGNOSISTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGDOOR CONTROL MODULE PROGRAMMING/RPO CONFIGURATION
2006 Chevrolet Tahoe 4WD V8-5.3L VIN T
Door Control Module Programming/RPO Configuration
2006 Chevrolet Tahoe 4WD V8-5.3L VIN TSECTION Door Control Module Programming/RPO Configuration
DOOR CONTROL MODULE PROGRAMMING AND SETUP
DRIVER DOOR MODULE
After replacing the driver door module (DDM), perform the programing procedure. Refer to Service Programming System (SPS).
PASSENGER DOOR MODULE
After replacing the passenger door module (PDM), perform the following programing and setup procedures:
- Service Programming System (SPS)
- Transmitter Programming in Keyless Entry
- Control Module Setup in Tire Pressure Monitoring
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.