Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006TAHOE 4WD V8-5.3L VIN TREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSOLAR SENSORSERVICE AND REPAIR
2006 Chevrolet Tahoe 4WD V8-5.3L VIN T
Solar Sensor: Service and Repair
2006 Chevrolet Tahoe 4WD V8-5.3L VIN TSECTION Service and Repair
SUN LOAD SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument panel upper trim panel.
2. Remove the sun load sensor (2) from the upper trim panel.
3. Disconnect the electrical connector.
INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the sun load sensor (2) to the upper trim panel.
3. Install the instrument panel upper trim panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.