Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006TAHOE 2WD V8-5.3L VIN TREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULELOCATIONSCOMPONENT LOCATIONS
2006 Chevrolet Tahoe 2WD V8-5.3L VIN T
Component Locations
2006 Chevrolet Tahoe 2WD V8-5.3L VIN TSECTION Component Locations
ABS Component Views
1 - Vacuum Booster
2 - Brake Pedal
3 - Stoplamp Switch
4 - Accelerator Pedal
5 - Stoplamp Switch Retainer
6 - Dash Panel
Electronic Brake Control Module (EBCM):
1 - Electronic Brake Control Module (EBCM)
2 - Electronic Brake Control Module (EBCM) Electrical Connector - C1
3 - Electronic Brake Control Module (EBCM) Electrical Connector - C2
4 - Frame
Left Side of Frame Rail - w/JL4:
1 - Electronic Brake Control Module (EBCM) - w/JL4
2 - Left Side Frame Rail
Precharge Pump (JL4):
1 - Brake Pressure Differential Switch Connector
2 - Master Cylinder Fluid Reservoir
3 - Brake Pressure Differential Switch
4 - Precharge Pump Connector
5 - Precharge Pump
6 - Frame
Traction Control Switch
Traction Control Switch (NW7):
1 - Traction Control Switch
2 - Instrument Panel Outer Air Outlet Housing
WheelSpeed Sensor - RF (2WD):
1 - Rotor
2 - Wheel Speed Sensor (WSS)
Wheel Speed Sensor - RF (4WD)
1 - Rotor
2 - Wheel Speed Sensor (WSS)
YAW and Lateral Acceleration Sensor (Escalade):
1 - Center Console
2 - YAW and Lateral Acceleration Sensor
3 - C306
YAW and Lateral Acceleration Sensor (Escalade EXT):
1 - Body Harness
2 - YAW and Lateral Acceleration Sensor
3 - YAW and Lateral Acceleration Sensor Connector
4 - HVAC Duct - Passenger Side
5 - Front Floor Panel - Passenger Side
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.