Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESSCAN TOOL DATA DEFINITIONS
2006 Chevrolet Tahoe 2WD V8-4.8L VIN V
Scan Tool Data Definitions
2006 Chevrolet Tahoe 2WD V8-4.8L VIN VSECTION Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
Battery Voltage: The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the BCM ignition feed input.
Cargo Door Ajar Switch: Input from the cargo door ajar switch indicating the liftgate status.
(Driver/Passenger) Door Ajar Switch (w/o DDM or w/o PDM)): Input from the respecting door indicating door status.
GM Part Number: The module's part number.
Ignition Accessory: Input from ignition switch Accessory circuit. Used to determine power mode. Hot in ACC and ON.
Ignition 0: Input to the control module from the ignition switch indicating the Ignition 0 position. Switch closed (HOT) in ignition switch positions UNLOCK, ACC, ON, and START
Ignition 1: Input to the control module from the ignition switch indicating the Ignition 1 position. Switch closed (HOT) in ignition switch positions ON and START.
Key in Ignition: Input from ignition switch indicating that the ignition key is inserted into the ignition switch. HOT with key in ignition switch.
Julian Date of Build: The day of the year when module was built.
Left Rear/Rear Cargo Door Ajar Switch: Input from the left rear/rear cargo door showing the state of it.
Right Rear Door Ajar Sw.: Input from the right rear door showing the state of it.
SWC Switch Power: Indicates the state of the supply voltage to the steering wheel controls supply voltage.
SWC Switch Voltage: Indicates the steering wheel controls supply voltage.
Year Module Built: The year when module was built.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.