HVAC Control Module Replacement - Auxiliary

2006 Chevrolet Tahoe 2WD V8-4.8L VIN VSECTION HVAC Control Module Replacement - Auxiliary


HVAC CONTROL MODULE REPLACEMENT - AUXILIARY

REMOVAL PROCEDURE




1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connectors (3,4) from the auxiliary HVAC control module (1).
3. Remove the screws from the auxiliary HVAC control module (1).
4. Remove the auxiliary HVAC control module (1) from the auxiliary HVAC module (2).

INSTALLATION PROCEDURE




1. Install the auxiliary HVAC control module (1) to the auxiliary HVAC module (2).
2. Install the screws to the auxiliary HVAC control module (1).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 1.6 N.m (14 lb in).

3. Connect the electrical connectors (3,4) to the auxiliary HVAC control module (1).
4. Install the right rear quarter trim panel.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.