Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006SILVERADO SS V8-6.0L VIN NREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERKEYLESS ENTRY TRANSMITTER BATTERYSERVICE AND REPAIR
2006 Chevrolet Silverado SS V8-6.0L VIN N
Keyless Entry Transmitter Battery: Service and Repair
2006 Chevrolet Silverado SS V8-6.0L VIN NSECTION Service and Repair
TRANSMITTER BATTERY REPLACEMENT
REMOVAL PROCEDURE
Under normal use, the battery in the transmitter will last about 2 years. For battery replacement, use a Panasonic(r) 3 volt, type CR2032, or equivalent.
1. Open the transmitter case and perform the following steps:
1. Insert a dime between the 2 halves of the transmitter near the key ring hole.
2. Twist the dime.
2. Remove the battery.
INSTALLATION PROCEDURE
1. Install the battery with the (+) positive side down.
2. Close the transmitter case and perform the following steps:
1. Align the top and bottom covers.
2. Press together the top and the bottom covers.
3. Inspect the operation of the transmitter.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.