Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006OPTRA (CANADA) L4-2.0LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER ARMSERVICE AND REPAIRWIPER ARM REPLACEMENT
2006 Chevrolet Optra (CANADA) L4-2.0L
Wiper Arm Replacement
2006 Chevrolet Optra (CANADA) L4-2.0LSECTION Wiper Arm Replacement
Wiper Arm Replacement
Removal Procedure
1. Open the hood.
2. If necessary, remove the cap to reveal the wiper arm nut.
3. Remove the nut from the wiper arm.
4. Pull the wiper arm off.
Installation Procedure
1. Install the wiper arm.
Notice: Refer to Fastener Notice Fastener Notice in Cautions and Notices.
2. Secure the wiper arm with the nut.
Tighten the wiper arm nut to 22 Nm (16 lb ft).
3. Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.