Steering Control Module: Service and Repair

2006 Chevrolet Optra (CANADA) L4-2.0LSECTION Service and Repair



Power Steering Control Module Replacement

Removal Procedure





Caution: Refer to Battery Disconnect Caution Battery Disconnect Caution in Cautions and Notices.

1. Disconnect negative battery cable.
2. Remove the glove box. Refer to Storage Compartment Replacement - Instrument Panel (I/P) Service and Repair in Instrument Panel, Gages, and Console.
3. Slide the speed sensitive power steering (SSPS) control module off from the control module bracket.
4. Disconnect the electrical connector from the SSPS control module.

Installation Procedure




1. Connect the electrical connector to the SSPS control module.
2. Slide the SSPS control module onto the SSPS control module bracket.
3. Install the ashtray.
4. Connect the negative battery cable.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.